Jump to content

Streckenbegrenzer - Beton 1.5.75 bekomme Support nur sehr schwer raus


Recommended Posts


ich habe angefangen die Beton Mauern hier aus dem 3D Bereich zu drucken. Leider bekomme ich den Support nur sehr schwer raus und dadurch gehen die Mauern kaputt oder sitzen nicht richtig.
Hat jemand hier einen Tipp was ich einstellen kann, dass der Support leichter aus den Lego Löschern raus geht ?

Dankes sehr



Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...

Important Information

In order to optimize our website for you and to continuously improve it, we use cookies. By continuing to use the website, you consent to the use of cookies. Further information on cookies can be found in our Privacy Policy